Auxiliary headlight motorbike: LED Nova for bracket 18-25mm

Let there be light! Motorbike auxiliary headlights LED NOVA

With the Nova LED auxiliary headlight set from HEPCO&BECKER, you get everything you need to improve the visibility and safety of your motorbike. This set includes powerful LED auxiliary headlights, a universal mounting set, a cable set, a switch, instructions and a tool set to conveniently mount and control the headlights. The Nova LED auxiliary headlights not only provide improved illumination of the road, but also give your motorbike an attractive appearance. Easy installation is made possible by the universal mounting kit and cable set supplied. Increase your safety and add an appealing design to your motorbike by using the HEPCO&BECKER LED motorbike auxiliary headlight set Nova.

The brand new LED auxiliary headlight Nova - the next step in lighting technology.

High-power LEDs with two switching levels at 2,500lm - 4,350K / - 5,500K
12 volt, 25 watts per headlight
ECE-tested and approved, so no individual approval is required (observe country-specific legal regulations for installation)
Improved lighting conditions in road traffic
Universal mounting on engine or tank protection bracket with Ø18mm - Ø25mm tube, can be mounted upright or suspended
complete headlight set; incl. 2x LED auxiliary headlights, 1x switch, 1x cable set, 2x clamps incl. reduction sleeves, 1x instructions, 1x tool set
Connection only via the battery, no connection to vehicle wiring harness required
No third-party operation thanks to special control unit with automatic voltage control
Waterproof and dustproof to IP67
Headlights can be added flexibly via the switch on the handlebars

Please note:

The lights can only be switched on approx. 5-15 seconds after starting the engine. A voltage of at least 13.1 V must be applied to the control unit of the wiring harness to enable the circuit . In older vehicles, this can be achieved by briefly increasing the speed.

Switching off must be done manually at the switch. The NOVA LEDs remain lit until the voltage limit of 11.8 V is reached, even after the engine has been switched off. Only when falls below this voltage limit do the lights switch off automatically via the control unit. When switching on again (wait for the dwell time of the control unit), the voltage limit of 13.1 V is queried again.

Download FAQ as PDF

5 years fair wear and tear.